 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| MicroPower Direct Miniature SIP, 2W Wide Input Range DC/DC Converters Key Features Miniature SIP Package 2W Output Power Remote ON/OFF 2:1 Input Voltage Range Regulated Outputs Low Cost D200RW Series Electrical Specifications Specifications typical @ +251C with nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice. Input Parameter Input Start Voltage Input Filter Reverse Polarity Input Current Short Circuit Input Power Conditions Min. Typ. 5 VDC Input 3.5 4.0 12 VDC Input 4.5 7.0 24 VDC Input 8.0 12.0 48 VDC Input 16.0 24.0 Internal Capacitor Max. 4.5 9.0 24.0 36.0 1.0 1,500 Conditions Vin = Min to Max Iout = 25% to 100% Over Line, Load & Temp. 120 50% Load Step Change Continuous Conditions 60 Seconds Flash Tested For 1 Sec 1,000 VDC 100 kHz, 1V Min. 1,000 1,100 1,000 100 Conditions Typ. Max. Units VDC VDC M pF kHz Units C C C % 100 3.0 0.01 300 5.0 0.02 Min. Typ. 1.0 0.3 0.5 30 Max. 2.0 0.5 0.75 50 75 15 Units VDC A mW Units % % % mV P - P mV P - P mV rms % Sec % %/C Output Parameter Output Voltage Accuracy Line Regulation Load Regulation Ripple & Noise (20 MHz) (Note 1) Ripple & Noise (20 MHz) Ripple & Noise (20 MHz) Output Power Protection Transient Response Time (Note 2) Transient Response Deviation Temperature Coefficient Output Short Circuit General Parameter Isolation Voltage Isolation Test Voltage Isolation Resistance Isolation Capacitance Switching Frequency 65 300 120 650 Max. +85 +90 +105 95 Environmental Parameter Operating Temperature Range Operating Temperature Range Storage Temperature Range Cooling Humidity Min. Typ. -40 +25 -25 +25 -55 Free Air Convection RH, Non-condensing Ambient Case Physical Case Size Case Material Weight 0.86 x 0.37 x 0.44 Inches (21.8 x 9.3 x 11.1 mm) Non-Conductive Black Plastic 0.17 Oz (4.8g) Conditions MIL HDBK 217F, 25C, Gnd Benign Conditions 5 VDC Input 12 VDC Input 24 VDC Input 48 VDC Input 1.5 mm From Case For 10 Sec All Models FAX: (781) 344-8481 Reliability Specifications Parameter MTBF Min. 1.0 Min. -0.7 -0.7 -0.7 -0.7 Typ. Max. Units MHours Units VDC C mW Absolute Maximum Ratings Parameter Input Voltage Surge (1 Sec) Lead Temperature Internal Power Dissipation MicroPower Direct TEL: (781) 344-8226 Typ. Max. 15.0 25.0 50.0 100.0 260 3,500 Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings. E-Mail: sales@micropowerdirect.com WEB: www/micropowerdirect.com Model Selection Guide Model Number D201RW D202RW D203RW D211RW D212RW D213RW D221RW D222RW D223RW D231RW D232RW D233RW Input Voltage (VDC) Nominal Range 5 4.5 - 9.0 5 5 12 12 12 24 24 24 48 48 48 4.5 - 9.0 4.5 - 9.0 9.0 - 18.0 9.0 - 18.0 9.0 - 18.0 18.0 - 36.0 18.0 - 36.0 18.0 - 36.0 36.0 - 75.0 36.0 - 75.0 36.0 - 75.0 Current (mA) Full-Load No-Load 471 40 548 534 184 217 209 96 109 103 49 57 53 40 40 20 20 20 10 10 10 8 8 8 100 Voltage (VDC) 3.3 5.0 12.0 3.3 5.0 12.0 3.3 5.0 12.0 3.3 5.0 12.0 Output Current (mA, Max) 500.0 400.0 167.0 500.0 400.0 167.0 500.0 400.0 167.0 500.0 400.0 167.0 Current (mA, Min) 125.0 100.0 42.0 125.0 100.0 42.0 125.0 100.0 42.0 125.0 100.0 42.0 Efficiency (%, Typ) 70 73 75 73 77 80 72 77 81 71 73 79 Fuse Rating Slow-Blow (mA) 1,500 1,500 1,500 700 700 700 350 350 350 135 135 135 Notes: 1. When measuring output ripple, it is recommended that an external 0.47 F ceramic capacitor be placed from the +Vout pin to the -Vout pin. 2. Transient recovery is measured to within a 1% error band for a load step change of 50 to 100%. 3. Operation at no-load will not damage these units. However, they may not meet all specifications. To maintain specified operation, the minimum output loading given in the table above must be maintained. 4. It is recommended that a fuse be used on the input of a power supply for protection. See the table above for the correct rating. Derating Curve 80 Output Power % 60 40 20 Remote ON/OFF Parameter Supply On Supply Off Standby Input Current Control Input Current (On) Control Input Current (Off) Control Common Min Max Under 1 VDC or Open Circuit 2.7 VDC 0.2 mA -0.4 mA 1 mA Referenced to -Vin (pin 1) 0 -40 -20 0 15 30 50 60 70 75 80 85 90 95 100 Ambient Temperature (C) Free Air 100 LFM 200 LFM 400 LFM Capacitive Load Models (Vout) Max. Capacitive Load 3.3V 2,200 5V 1,000 12V 170 Units F Mechanical Dimensions Side View 0.44 (11.1) 0.02 (0.5) Pin Connections Pin Function -Vin +Vin Remote ON/OFF No Function +Vout -Vout No Function 1 2 3 5 6 7 8 Mechanical Notes: * All dimensions are typical in inches (mm) * Tolerance x.xx = 0.01 (0.25) * Pin 1 is marked by a "dot" or indentation on the side of the unit * Leads are tin plated for improved solderability. 0.126 (3.2) 0.10 (2.5) 0.08 (2.0) 0.70 (17.8) 0.86 (21.8) Bottom View 1 2 3 5 6 7 8 0.37 (9.3) 0.01 (0.25) 0.02 (0.5) 0.05 (1.25) MicroPower Direct 232 Tosca Drive, Stoughton, MA 02072 www.micropowerdirect.com sales@micropowerdirect.com phone: (781) 344 - 8226 * fax: (781) 344 - 8481 |
Price & Availability of D201RW
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |